43
SINGLE PASS HALF-BLIND DOVETAILS
Chapter 10Super Jig-12-18-24 User Guide
10-26 Tail Boards
5
/8"[16mm] and thicker.
Use the same procedure to rout “single pass” dovetails with side
thicknesses from
5
⁄8" to 1"[16 to 25mm] except:
The stop rod is not used
and the initial scale setting is
5
⁄8"[16mm]
for all boards
. Hint: Set the e7-Bush to lower than 10 for deeper
cuts in drawer fronts.
■
To Next Page
Loading...