Leisure RI85421 - Removing the Transit Bolts; Connecting Water Supply

20 / EN
Washer-Dryer
Installation

A
PRECAUTION
• Do not remove the transit bolts before removing the
packagingreinforcement.
• Removethe transitbolts beforeoperatingthe washing
machine!Otherwise,theproductwillgetdamaged.
3
2
1
1 Use a tool to loosen all bolts until they rotate freely.
2 Remove the transit bolts by turning them slightly.
3 Attach the plastic covers supplied in the user manual bag into the holes on the rear
panel.
C
INFORMATION
• Keepthetransitboltsinasafeplacetoreusewhenthe
productneedstobemovedagaininthefuture.
• Nevermovetheproductwithoutthetransitboltsproperly
fixedinplace!

C
INFORMATION
• Thewatersupplypressurerequiredtoruntheproductis
between1to10bars(0.1–1MPa).Itisnecessarytohave
10–80litersofwaterflowingfromthefullyopentapin
oneminutetohaveyourproductrunsmoothly.Attacha
pressurereducingvalveifwaterpressureishigher.
A
CAUTION
         
          


 
