60 / EN
Washer-Dryer
Service life of product extends and frequently experienced problems will be reduced
if it is cleaned at regular intervals.
Remove any powder residue buildup in the drawer. To do this;
1. You can remove the detergent drawer by pulling it towards yourself strongly.
C
INFORMATION
• If more than a normal amount of softener and liquid
detergent mixture starts to remain in the softener
compartment,thesiphonmustbecleaned.
2. Wash the drawer and the siphon with plenty of lukewarm water in a washbasin.
Wear protective gloves or use an appropriate brush to avoid touching the residues
in the drawer when cleaning.
3. Replace the drawer into its housing after cleaning. Check if the siphon is in its
original location.
For products with drum cleaning programme, please see Operating the product -
Programmes.
For products without drum cleaning programme, follow the below steps to clean
the drum:
Select Additional Water or Extra Rinse auxiliary functions. Use Cottons
programme without pre-wash. Set the temperature to the level recommended
on the drum cleaning agent which can be found in the detergent aisle in
supermarkets. Apply this procedure without any laundry in the product. Before
starting the programme, put 1 pouch of special drum cleaning agent (if the special
agent could not be supplied, put max. 1 tea-cup of (max. 100 g) of antilimescale
powder) into the main wash detergent compartment. If the antilimescale is in tablet
form, put only one tablet into the main wash compartment no. "2". Dry the inside of
the bellow with a clean piece of cloth after the programme has come to an end.
Maintenance and cleaning
To Next Page
Loading...