Leisure RI85421 - Cleaning the Body and Control Panel; Cleaning the Water Intake Filters

User’s Manual
61 / EN
Maintenance and cleaning
C
INFORMATION
• RepeatDrumCleaningprocessinevery2months.
• Useananti-limescalesuitableforthewashingmachines.
After every washing and drying make sure that no foreign substance is left in the
drum.
If the holes on the bellow shown in the figure are blocked, open the holes using a
toothpick.
C
INFORMATION
• Foreign metal substances will cause rust stains in the
drum. Clean the stains on the drum surface by using
cleaningagentsforstainlesssteel.Neverusesteelwool
orwirewool.
A
CAUTION
        


Wipe the body of the machine with soapy water or non-corrosive mild gel detergents
as necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.

There is a filter at the end of each water intake valve at the rear of the machine
and also at the end of each water intake hose where they are connected to the tap.
These filters prevent foreign substances and dirt in the water to enter the washing
machine. Filters should be cleaned if they are dirty.