The safety decal 'Area with unmanned autonomous vehicle' must be
installed on a highly visible place near the entrance of the barn.
Figure 9. Position of the safety decals
KEY:
1. Electric Shock - High Voltage Symbol - 2. 'Do not sit on the vehicle' and 'Keep safe
distance' decal - 3. Rotating Parts - Entanglement Hazard Symbol
2.4.2 Installation of Safety Decals
1. Make sure the installation surface is clean and dry.
2. Make sure the temperature of the mounting surface is not less than 5
°C (41 °F).
3.
Identify the correct position for the decal before you remove the
backing paper.
4. Remove a small part of the backing paper.
5. Put the decal in the correct position on the mounting surface and
carefully press the small part of exposed adhesive surface of the
decal onto the mounting surface.
6. Slowly remove the backing paper and attach the rest of the decal to
the mounting surface.
7. Puncture small air pockets in the decal with a pin and use the backing
paper to smooth the decal.
Safety 2-7
5.4301.8501.0 A Lely Control
To Next Page
Loading...
