LELY JUNO 150 - Battery Stop

2.4.3 Maintenance of Safety Decals
Safety decals on the JUNO 150 Feed Pusher display important and useful
information that will help you safely operate and maintain the JUNO 150.
Obey the instructions below to make sure all the decals stay in the correct
position and condition.
• Keep the safety decals clean and legible at all times. Clean the safety
decals with soap and water. Do not use mineral spirits, abrasive cleaners
or other similar agents that may damage the safety decals
•
Replace safety decals that are missing or are illegible
• Safety decals can be purchased from your local Lely service provider.
2.5 Safety Devices
2.5.1 Emergency Stop Button
An emergency stop button (see figure on page 2‑11) is installed on the top
of the JUNO 150. The emergency stop button is accessible with
the cover of
the JUNO 150 closed (see figure on page 4‑
1).
When the button is pressed, the JUNO 150 immediately stops operation.
To reset the emergency stop button, turn the button counter clockwise and
pull it out until it unlocks.
2.5.2 Pause button
A pause button is installed on the JUNO 150. When the pause button is
pushed while the JUNO 150 is in operation, the JUNO 150 goes into pause
mode:
• The JUNO 150 stops.
• The LED light in the pause button turns on.
• The operational sound of the JUNO 150 is turned off.
• The user interface on the smartphone displays a question to resume or
cancel the route.
When the pause button or the button in the Lely Control app is pushed
shortly while the JUNO 150 is in pause mode, the JUNO 150 goes back into
work mode:
• The JUNO 150 goes back into operation.
• The LED light in the pause button turns off.
• The operational sound of the JUNO 150 is turned on.
The pause button can be operated remotely with the Lely Control app on the
smartphone.
If an alarm occurs, the LED in the pause button blinks. The alarm must be
confirmed with the Lely Control app on the smartphone.
2-8 Safety
5.4301.8501.0 A Lely Control