6.4 Maintenance Procedures
Danger of being entangled by rotating parts.
Keep hands, loose clothing, and long hair away from moving parts
during operation of the JUNO 150.
6.4.1 Clean the Charging Strips and the Charging Electrodes
Make sure that after cleaning the charging electrodes slide over the
middle of the charging strips when the JUNO 150 parks.
Preparation
1.
Disconnect the main power supply to the charging station.
2.
Manually drive the JUNO 150 to a clean and quiet location (page 5‑4).
Clean
1. Thoroughly clean the charging strips (see figure on page 6‑6) (1) of
the JUNO 150 with sand paper.
2. Thoroughly clean both electrodes of the charging station (2) with a
brush or sand paper.
Close-up
1. Connect the charging station to the main power supply.
2. Manually drive the JUNO 150 to the charging station.
3. Examine the charging electrodes slide over the middle of the charging
strips when you park the JUNO 150.
4. Start the time path to put the JUNO 150 into operation (page 5‑15).
Maintenance 6-5
5.4301.8501.0 A Lely Control
To Next Page
Loading...
