The LED in the pause button still blinks. On the smartphone the message
'Push the pause button to release the safety circuit' is displayed.
2. Push the pause button on the JUNO 150. The JUNO 150 goes into
pause mode. The LED in the pause button is continuously on.
'Continue with current route?' is displayed on the smartphone.
Continue normal operation
When the alarm is confirmed, on the smartphone press:
•
[Yes] to continue the current route.
Or:
• [No] to go to the main menu.
1. Select 'Alarms' > 'Alarm list'. The display displays the number, the
date and time when the alarm occurred and the alarm number, see
the example below.
2. Note the alarm number and refer to the alarm list (page 8‑1).
3. Do the recovery procedure described in the alarm list.
No. Date Time Alarm
1 4-1 22:17 7
2 4-1 21:33 10
Select an alarm in the list and push [ ] to open the alarm message for
extra information.
Or:
• [
MAN] to put the JUNO 150 in a proper position to continue with the
current route. The message 'SAFETY WARNING. Manual operation is
permitted only with a clear overview of the vehicle. Confirm?' appears on
the smartphone display.
1. Confirm if you have a clear overview of the JUNO 150.
2. Press 'Esc' > [Yes] to continue with the current route.
8.2.2 Alarm List
The table below gives the alarm numbers and any actions to be taken:
8-2 Troubleshooting
5.4301.8501.0 A Lely Control
To Next Page
Loading...
