LELY JUNO 150 - Define the Push Power for a Feed Group; Set a Time Path; Make a Backup

5.11.8 Define the Push Power for a Feed Group
1. Open the Lely Control app on the smartphone
2. Stop the time path to take the JUNO 150 out of operation (page 5‑
15).
3.
In the main menu of the Lely Control app, select 'Routes' and push
[ ].
4.
Select 'Feed push power' and push [ ].
5.
Select the applicable feed group and push [ ].
6.
Select the applicable push power and push [ ].
7. Push button [ESC].
5.11.9
Set a Time Path
1. Open the Lely Control app on the smartphone.
2. Stop the time path to take the JUNO 150 out of operation (page 5‑
15).
3.
In the main menu of the Lely Control app, select 'Routes' and push
[ ].
4.
Select 'Time path' and push [ ].
Refer to the time path description.
The JUNO 150 must not drive more than 40% of the total time in a time path.
It must spend minimum 60% of the total time charging at the charging
station.
5.
Push soft button [New].
6. Push soft button [>].
7.
Push [ ] to select the start time (hour) and push soft button [>].
8.
Push [ ] to select the start time (minutes) and push soft button [>].
9.
Push [ ] to select the route and push soft button [>].
10.
If you want:
•
To add another route to the time path, push soft button [New] and
repeat steps 7 to 11
• Confirm an go up one level, push [ESC].
11. Push soft button [Yes] to save the new time path.
5.11.10 Make a Backup
Make a backup each time you change a route or time path or when another
smartphone is used. Backups are made on the smartphone.
Make sure to give each backup you make a unique name.
Operating Instructions 5-13
5.4301.8501.0 A Lely Control