LELY SPLENDIMO 240 M - Intermittent Maintenance

EN-15
7.3 Intermittent maintenance
Intermittent maintenance has to be carried out:
• at the start of the mowing season;
• before prolonged storage of the machine;
• when the machine is used extensively during the season.
- Grease all points of the machine listed in § 7.2 “Lubrication”.
- Grease the spring-loaded locking pins of the yoke lock of the PTO
shaft.
- Check if the PTO shaft telescopes smoothly.
A damaged PTO shaft may cause excessive wear and tear to the
machine and tractor.
- Check correct pretension of 160 mm of the spring of the
breakback device (fig. 16).
- Check the condition of the wear plates, mower discs and knives
(replacement of knives: see § 7.4).
- Check the knife pins for tightness (fig. 17).
The clip must be properly locked by the cam of the mowing disc.
- Check the mower discs for tightness (fig. 17). Castellated nut
torque is 150-250 Nm (15-25 kgm). The split pin locking the
castellated nut is not allowed to protrude above the pressure piece.
Attention: it is not allowed to turn the nut back; keep turning until
the split pin can be fitted.
- Check the machine for damage and flaws.
- Check the gearboxes for oil leakage.
(Refreshment of oil: see § 7.5.)
17
150-250 Nm (15-25 kgm)