EN-19
7.6 Change of grease in mower
elements
Replace the grease in the mower elements every 500 working hours
or every 1,000 hectares.
Follow the directions listed hereafter.
- Remove the mower disc.
If several bearing housings need to be dismounted, care should
be taken that they are fitted back on the original mower
elements.
- Dismount the bearing housing A (fig. 24) from the element. Make
sure that the shims B remain in place.
- Remove the grease from the element. Do not use a solvent since
it may affect the sealing of the bearings and/or rinse the grease fill
out of the bearings.
Measure the grease quantity carefully. An incorrect quantity
may cause overheating and damage of the element.
- Fill the elements with 95 grams of grease (Shell Alvania WR 0).
- Place the bearing housing on the element. Turn the hub (C,
fig. 24) so that it is aligned with the hub of the adjacent mower
element (fig. 25).
- Apply Loctite 243 to the thread of the fillister head screws and
tighten them with a torque of 39 Nm (3.9 kgm).
- Check the presence of the O-ring D (fig. 25) in the pressure piece.
- Fit the mower disc. Tighten the castellated nut with a torque of
150-250 Nm (15-25 kgm). Secure the castellated nut with a split
pin. Make sure that the split pin does not protrude above the
pressure piece.
To Next Page
Loading...
