31
− Switch on the boundary wetting with the
lever (6), the agitating nozzle with the
lever (9) and the canister rinsing with the
lever (11).
− Close the cover.
− Operate the pump(s) at low speed for a
short time.
− Put the induction valve (8) in the
“induction ON” position.
− After the cleaning is completed:
− Put the levers for the agitating nozzle
(9), canister rinsing (11) and boundary
wetting (6) in their respective “OFF”
positions.
− Put the induction valve (8) in the
“induction OFF” position and the
distribution valve (7) in the “spraying”
position (crosswise lever).
− Agitate the content of the main tank.
It must be ensured that the internal cleaning of the chemical inductor is done at
low pump speed otherwise too much clean water will be taken from the clean
water tank in a short time. This has the result that there is not enough clean water
in the clean water tank for a system cleaning, internal cleaning of the main tank
and outside cleaning.
ATTENTION! Never operate the lever (11) of the canister rinsing if there is no
canister pushed over the canister rinsing nozzle. The canister must
only be rinsed with clean water.
8
7
9
6
11
To Next Page
Loading...