37
− Switch on the pump and operate at low
speed until clean water discharges from
the nozzles.
− Switch off pump.
− Put the main switch on the on-board
computer in the “spray boom OFF”
position.
− Use the pressure adjustment to put the
spraying pressure back in the middle
position.
− Put the controller in the “automatic”
position.
− Put selection valve in the “main tank”
position
ATTENTION!
During the spraying of the cleaning fluid at
the end of the field or before turning on the
headlands, only switch off the pump(s) and
switch on again after the turn. The
switches (9) of the boom sections and the
main switch (10) must stay in the spraying
position during the turn otherwise liquid
can get into the main tank and the
concentration of the spray mixture would
be changed.
5 6
7
10
9
8
10
8
9
To Next Page
Loading...