Lemon RX Stabilizer PLUS Receiver – Essential Instructions v.1.5
17
Annexes
Annex A: What do those tiny cryptic letters on the label mean?
Annex B: Stabilizer Mode Settings
The inputs required by the Stabilizer PLUS on channel 5 (Gear) do not need to be exact. The following ranges
will be recognized as defining the three Stabilization modes:
• Any value below -36% (pulse length 1356us) will put the unit into Autolevel mode.
• Any value between -35% (1360us) and +35% (1640us) will invoke Gyro mode.
• Any value above +36% (1644us) will turn the Stabilizer OFF.
Annex C: Setting up a Current Generation Spektrum Transmitter for the StabPLUS
The following should apply with only minor adjustments to such recent transmitters as the DX6, DX6e, DX7s,
DX8G2, DX9, and DX18 (not DX6i, DX7, DX8). Updating to the latest firmware is recommended.
1. Select a new model (or do a reset on a previously used model memory) and name it appropriately.
2. For a single aileron servo, or two servos on a Y-cable, set Aircraft Type to Normal Wing, Normal Tail.
For two servos on separate channels (2 and 6), set Aircraft Type to Dual Aileron.
3. Under Channel Assign, leave Rx Port Assignments as is.
4. Under Channel Assign, (second page), set Channel Input Config to a suitable 3-way switch (such as D)
for channel 5 (Gear) and to RKnb for channel 8 (Aux3), if available. Inhibit any unused channels.
5. In Trim Setup, set Throttle to 0 to disable throttle trim.
6. Set up D/R and Expo as required on a suitable switch.
7. Set up Throttle Cut to -100% on a suitable switch (most commonly H).
Further examples of transmitter setups are provided in the Lemon Stabilizer Plus Configurations thread.
To Next Page
Loading...