11
Preparation of Remote Control
Follow the steps below to install the battery.
1. Pull the battery holder out from the remote control in the direction of the arrow.
2. Load a new battery properly with the (+) sided up.
3. Insert the battery holder back into the original position.
Use of Remote Control
Point the remote control unit from no more than about 5m from the remote control
sensor and within about 60 degrees of the front of the unit.
Under normal use the battery will last for
six months.
Improper use of the battery may cause
overheating, explosion or ignition, which
can result in an injury or a fire. Battery
leakage may damage the remote control.
Do not expose the remote control unit to
direct sunlight.
Do not recharge, disassemble, deform or
heat the battery.
Do not put the battery in fire or water.
Immediately replace the exhausted battery.
Take out battery when the remote is not in
use for a long time.
System Connections
To Next Page
Loading...
