11
values for each mobile device. The thermostat will not show the Smart Away
indication until all devices have moved past their inner away fence, and the
system will not reach the user-set away set points until all devices have moved
past their outer fence.
NOTE: Smart away will be canceled when the system is enrolled in energy
savings with a utility provider and a energy saving event is active.
Feels Like
The feels like feature uses a combination of outdoor temperature and indoor
humidity to come up with the feels like comfort level in the home.
NOTE: Feels Like is not a temperature setting but the temperature that the
space feels like based on current outdoor temperature and indoor
humidity. To adjust Feels Like, lower indoor temperature, or both
indoor temperature and humidity percentage settings.
NOTE: When Feels Like is set to on, the words Feels Like will appear above
the indoor temperature display on the home screen.
feels like
feels like
Display and control your system using feels like temperatures instead of actual temperatures
on
indoor
humidity
indoor
temperature
outdoor
temperature
feels like
++
Feels like temperatures factor in the outdoor temperature
and indoor humidity for more accurate control of the temperatures in your home
= 75°
Figure 10. Feels Like Screen
Fan
Allergen Defender: Go to menu > settings > fan to turn on or off Allergen
Defender. When Internet weather is enabled and pollen count is high in the
home’s zip code, the fan will run between heating or cooling systems to help
clean the air.
Fan Mode Options: Circulate air can be adjusted on this screen. Adjustments
between 9 to 27 minutes on how long the air will circulated each hour. The
circulate option runs during any mode selected except when the system is
turned off.
Ventilation
This option will only appear if a fresh air damper, ERV or HRV is installed and
congured by your installer. Either ERV or HRV could be congured as single
or two-stage if applicable.
Menu Selection
When selecting this menu option, selections will be either:
• Timed or ASHRAE (either Timed or ASHRAE is set by your installer during
setup of your thermostat).
• On (always)
• Off (always).
Factory default is ASHRAE. Your installer will need to change it to Timed if that
mode is desired.
You can also select “ventilate now” to start a ventilation function immediately.
Those menu options are 10, 20, 30, 40 and 50 minutes, 1 hour, 1-1/2 hours, 2
hours, 2-1/2 hours, 3 hours, 3-1/2 hours and 4 hours and custom. Custom will
allow to set a specic time to run too.
NOTE: On two-speed ventilators, when ventilate now is selected, the
ventilator will come on at high speed.
NOTE: Once ventilation is started, a notication appears on the right-side of
the home screen indicating a time when that specic cycle will end and
the option to cancel the demand.
2:31 am
set−to
76
inside
57%
auto
away
0
modes /schedules
80
tue | Mar 31, 2015
Home
Figure 11. Ventilation Home Screen Notications
To Next Page
Loading...
Need help?
General
