44
7.3. How to Enable or Disable Increased Dehumidification Mode
Go the MAIN MENU > SETUP > INSTALL. Follow the prompts until you reach MODEL NUMBER. Enter the Ultra-High
Efficiency model number here. Touch SAVE to proceed. Continue through the various configuration problems until you
reach DEHUM SENSOR TYPE. By default it is set to DISABLED. ENABLED and select one of the following Increased
Dehumidification mode sensor types:
LOCAL SENSOR > DEHUMID SETPOINT > DEHUMID DEADBAND > OVERCOOL LIMIT
NETWORK SENSOR > DEHUMID SETPOINT > DEHUMID DEADBAND > OVERCOOL LIMIT
REHEAT DI4
To Next Page
Loading...
