Lennox VRF VEWCL1E - Parameter Setting Guide

Wired Controller VEWCL1E
27
Parameter Name Range Parameter Name Range
Comp2 Operation Freq
0～200Hz
ODU Fan Operation Freq
0～100Hz
Module High Pressure
-40～70℃
Module Low Pressure
-69～38℃
Comp1 Discharge Temp
-30～150℃
Comp2 Discharge Temp
-30～150℃
Comp3 Discharge Temp
-30～150℃
Comp4 Discharge Temp
-30～150℃
Comp5 Discharge Temp
-30～150℃
Comp6 Discharge Temp
-30～150℃
Comp3 Operation Freq
0～200Hz
ODU Heating EXV1
0～48
ODU Heating EXV2
0～48
Subcooler EXV
0～48
Defrosting Temp
-30～139℃
Subcooler Liquid Temp
-30～139℃
Separator Outlet Temp
-30～139℃
Oil Return Temp
-30～139℃
Condenser Inlet Temp
-30～139℃
Condenser Outlet Temp
-30～139℃
Remark: there are no equipped remote controls for current wired controllers. The
remote receiving function is only the reserved function.
6.2.2 Setting of Parameters
Parameters of unit can be set under both ON and OFF status.
In the homepage, press “
” to enter into the menu page, and then select “set” to
enter into the setting page; in the setting interface, select “project set” to enter into the
page, as shown below, for the settable parameters please the following Table 6.3
and Table 6.4.