Lennox VRF VEWCL1E - Setting of Modes

Wired Controller VEWCL1E
36
Fig. 7.1 Unit-ON interface
Fig. 7.2 Unit-OFF interface
7.2 Setting of Modes
Under ON status, each time pressing the “ ” button in the homepage, the mode
will be switched as the following order circularly:
Auto->
Cool -> Dry -> Fan -> Heat ->Floor ->3D Heat -> Space -> Auto
Note:
① The supporting modes differs due to different models, the wired controller will
automatically select the setting range of mode according to model of IDU;
② Only master IDU can set the Auto mode (t not applicable to heat recovery
units);