Wired Controller VEWCL1E
42
Lock: under lock status, any button operation are invalid, user should operate
according to the prompt to unlock the function.
Light: this function can set the ON and OFF of light in light plate of IDU.
Rapid: it is used to fast increase or decrease temperature to the set value when
starting the unit. The fast function can only be activated under Cool or Heat mode.
Absence: this function is used for maintaining the indoor ambient temperature
and ensuring fast heating after starting the unit. The Absence function can only be
activated under Heat mode.
X-fan: it is used for removing the water in the evaporator of IDU after turning off
the unit to prevent mildew. The dry function can only be activated under Cool or Dry
mode.
Health*: it can turn on or turn off health function.
12-Drying: this function can only be activated under Dry mode, after it is
activated, the set temperature of Dry mode becomes 12ā.
E-heater*: under Dry mode, in order to prevent the air-out temperature is too low,
it is allowed to turn on the auxiliary electric heating to increase the air-out
temperature; under Heat and 3D Heat mode, it is allowed to turn on the auxiliary
electric heating to improve the heating efficiency. Turn off the auxiliary electric
heating under Heat and 3D Heat mode can save energy.
To Next Page
Loading...
