Lenovo Neptune DWC RM100 - LOG-IN Screen; Fig.7 - Control System Alarms Screen; Fig.8 - Control System Log-In Screen

CDU Operating & Maintenance Guide Page 13
Neptune DWC RM100 in-rack Coolant Distribution Unit
2.2.6 LOG-IN Screen
The Log-in screen allows the user access to further information and to adjust various parameters and
settings when logged-in at Service or Engineer level.
No access code (User Level 1) – provides access to Login, Status, Data Curves and Alarm pages
Code 1234 (User Level 2) – provides Read Only access to Setup, Configuration and Diagnose
menus
Code 5699 (Service Level) – provides full read only access to everything and write access to select
configuration and service features
Code xxxx (Engineer Level) – full read/write access to all features
Code xxxx (+Engineer Level) – enter after Eng. Level code for Factory Setup
Log-in codes are available on request from the manufacturer. Entering an invalid code will result in the
following message: -
Fig.7 – Control System Alarms screen
Fig.8 – Control System Log-in screen