2. Prepare your server. See “Removing or extending the server from the rack cabinet” on page 75.
3. Remove the server cover. See “Removing the server cover” on page 75.
4. Locate the failing tape drive and disconnect the cable from the rear of the tape drive. Remove any
parts and disconnect any cables that might impede your access to the tape drive. See “Front view of
the server” on page 20.
5. Remove the five screws that secure the tape drive cage to the chassis. Then, remove the tape drive
cage from the front of the server.
Figure193.Removingthetapedrivecage
194ThinkServerRD650UserGuideandHardwareMaintenanceManual
To Next Page
Loading...
