2. Remove the holder from the bracket.
Remove the screw that secures the holder to the bracket.
Slide the holder forward slightly to disengage it from the bracket, and remove the holder.
Figure 55. Removing the horizontal holder from the bracket
Then, recycle the component in compliance with local regulations.
Install a flash power module
Follow instructions in this section to install a flash power module.
About this task
Attention:
• Go over “Installation Guidelines” on page 107 to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure. A video of this procedure is available from the following links:
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Install the flash power module.
Chapter 4. Hardware replacement procedures 139
To Next Page
Loading...
