• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Install the PCIe riser assembly to zone 2.
Figure 81. Installing the PCIe riser assembly to zone 2
If a filler has been installed, remove it.
Align the PCIe riser assembly with the connector on the system board, and push it in.
Connect the PCIe cable to PCIe connector 5 on the processor and memory expansion tray.
After this task is completed
1. Reconnect all the required cables.
2. Proceed to complete the parts replacement (see “Complete the parts replacement” on page 218).
Power backplane replacement
Follow instructions in this section to remove or install the power backplane .
Remove the power backplane
Follow instructions in this section to remove the power backplane.
About this task
Attention:
Chapter 4. Hardware replacement procedures 167
To Next Page
Loading...
