Lenovo ThinkSystem SR850 V2 - Front View

Front view
This section contains information about the controls, LEDs, and connectors on the front of the server.
Figure 5. Front view
Table 3. Components on the front view
1
“VGA connector (optional)” on page 15
8
“System error LED (yellow)” on page 16
2
“External LCD diagnostics handset
connector” on page 15
9
“Network activity LED (green)” on page 16
3
“Drive status LED (yellow)” on page 15
10
“USB 1” on page 16 (USB 2.0 with Lenovo XClarity
Controller management)
4
“Drive activity LED (green)” on page 16
11
“USB 2” on page 16 (USB 3.1)
5
“2.5-inch drive bays” on page 16
12
“Pull-out information tab” on page 16
6
“Power button/LED (green)” on page 16
13
“Rack release latches” on page 17
7
“Identification button/LED (blue)” on page 16
1 VGA connector (optional)
Connect a monitor to this connector.
Notes:
• When the optional front VGA connector is in use, the rear one will be disabled.
• The maximum video resolution is 1920 x 1200 at 60 Hz.
2 External LCD diagnostics handset connector
Connect the external LCD diagnostics handset here. See “External LCD diagnostics handset” on page 17 for
more details.
3 Drive status LED (yellow)
These LEDs indicate the following status:
• The LED is lit: the drive has failed.
• The LED is flashing slowly (once per second): the drive is being rebuilt.
• The LED is flashing rapidly (three times per second): the drive is being identified.
Chapter 2. Server components 15