Two-AnyBay-backplane combinations
Follow the instructions in this section to learn how do cable routing for combinations with two AnyBay
backplanes.
Note: These combinations require four installed processors.
See the following sections for cable routing combinations with two AnyBay drive backplanes.
• “Without PCIe switch card” on page 89
– “Two backplanes” on page 89
– “Three backplanes” on page 91
• “With PCIe switch card” on page 95
– “Two backplanes” on page 96
– “Three backplanes” on page 97
Without PCIe switch card
Follow the instructions in this section to learn how do cable routing for combinations with two AnyBay
backplanes and not PCIe switch card.
Note: See “Connecting cables to the processor and memory expansion tray” on page 48 to perform the
procedure properly while connecting PCIe cables to the processor and memory expansion tray.
Two backplanes
Two AnyBay backplanes
Chapter 3. Internal cable routing 89
To Next Page
Loading...
