CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
• Go over “Installation Guidelines” on page 107 to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure. A video of this procedure is available from the following links:
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Install the top cover.
Figure 127. Installing the top cover
Place the top cover over top of the server with both sides aligned.
Rotate the latch down until it stops.
Step 2. (Optional) Lock the top cover with a screw driver (direction
2 ).
Chapter 4. Hardware replacement procedures 217
To Next Page
Loading...
