Simple-swap-drive backplate
Use the section to understand the cable routing for the simple-swap-drive backplate.
This topic contains the following information:
• “Server models with four 3.5-inch simple-swap drives (software RAID)” on page 39
• “Server models with eight 3.5-inch simple-swap drives (software RAID)” on page 40
Server models with four 3.5-inch simple-swap drives (software RAID)
Use this section to understand the cable routing for server models with four 3.5-inch simple-swap drives
(software RAID).
Figure 25. Cable routing for server models with four 3.5-inch simple-swap drives (software RAID)
Note: Ensure that all cables are routed through the correct cable clips.
Cable
From To
Simple-swap disk drive cable SAS connector on the backplate
1 Backplane 1 power connector on the
system board
2 SATA 0–3 connector on the system
board
Chapter 2. Server components 39
To Next Page
Loading...
