Figure 40. Simple-swap drive backplate installation
Step 3. Press the drive cage in until the release latch clicks into place (see “Install the 3.5-inch/2.5-inch
drive cage” on page 59).
Install a 2.5-inch SSD into a 3.5-inch drive bay
Use this information to install a 2.5-inch SSD into a 3.5-inch drive bay.
“Read the
installation
Guidelines” on
page 54
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 55
Before installing a 2.5-inch SSD into a 3.5-inch drive bay:
1. Watch the procedure. A video of this procedure is available from the following links:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Dy5N2dPXFx5Pht-FljAi6S
• Youku: https://list.youku.com/albumlist/show/id_51977169
To install a 2.5-inch SSD into a 3.5-inch drive bay, complete the following steps:
Step 1. Locate the appropriate drive bay.
Step 2. If necessary, remove the 3.5-inch drive tray.
Step 3. Position the 2.5-inch SSD into the 2.5-inch to 3.5-inch drive adapter.
Chapter 3. Server hardware setup 61
To Next Page
Loading...
