Figure 52. Hot-swap power supply installation
Install the M.2 drive
Use this information to install the M.2 drive.
“Read the
installation
Guidelines” on
page 54
“Power off
the server for
this task” on
page 86
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 55
Before installing the M.2 drive:
1. Watch the procedure. A video of this procedure is available from the following links:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Dy5N2dPXFx5Pht-FljAi6S
• Youku: https://list.youku.com/albumlist/show/id_51977169
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
3. Obtain a #1 Phillips screwdriver and a 4.5mm hex socket screwdriver
To install the M.2 drive, complete the following steps:
Two different M.2 drive lengths are supported by the server - 42mm and 80mm drives. If necessary, by using
a 4.5mm hex socket screwdriver, remove the standoff and screw it to the appropriate mounting point to
accommodate the specific drive.
74
ThinkSystem ST250 Setup Guide
To Next Page
Loading...
