Figure 62. Server cover installation (2)
Step 3. Use a screwdriver to tighten the thumbscrew on the server cover to secure the server cover in
place.
Cable the server
Attach all external cables to the server. Typically, you will need to connect the server to a power source, to
the data network, and to storage. In addition, you will need to connect the server to the management
network.
Connect to power
Connect the server to power.
Connect to the network
Connect the server to the network.
Connect to storage
Connect the server to any storage devices.
Power on the server
After the server performs a short self-test (power status LED flashes quickly) when connected to input power,
it enters a standby state (power status LED flashes once per second).
Chapter 3. Server hardware setup 85
To Next Page
Loading...
