Figure 53. Moving standoff to appropriate mounting point
Table 12. Standoff location on system board
Callout Callout
1 Standoff for 42 mm M.2 drive 2 Standoff for 80 mm M.2 drive
Step 1. Insert the M.2 drive at an angle into the connector; then, rotate it.
Step 2. Using a #1 Phillips screwdriver, tighten the screw that you saved earlier to secure the drive to the
system board.
Figure 54. M.2 drive installation
After installing the M.2 drive, use the Lenovo XClarity Provisioning Manager to configure the RAID. For more
information, see:
http://sysmgt.lenovofiles.com/help/topic/LXPM/RAID_setup.html
Install an optical drive
Use this information to install an optical drive.
Note: When a standalone optical drive is be installed, you will need to additionally purchase the
ThinkSystem ST250 ODD/Tape Cable Kit option in order to install the drive.
“Read the
installation
Guidelines” on
page 54
“Power off
the server for
this task” on
page 86
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 55
Chapter 3. Server hardware setup 75
To Next Page
Loading...
