Figure 27. Cable routing for server models with four 3.5-inch hot-swap drives (hardware RAID)
Cable
From To
1 Power cable for backplane 1 Power connector on backplane 1 Backplane 1 power connector on the
system board
2 SAS signal cable for backplane 1 SAS connector on backplane 1
An available connector on the RAID
adapter
Server models with eight 3.5-inch hot-swap drives (hardware RAID)
Use this section to understand the cable routing for server models with eight 3.5-inch hot-swap drives
(hardware RAID).
Note: Ensure that all cables are routed through the correct cable clips.
42
ThinkSystem ST250 Setup Guide
To Next Page
Loading...
