Chapter 2. 2-8
Selecting a supported display mode
The display mode the monitor uses is controlled by the computer. Therefore, refer to your
computer documentation for details on how to change display modes.
The image size, position and shape might change when the display mode changes. This is
normal and the image can be readjusted using automatic image setup and the image controls.
Unlike CRT monitors, which require a high refresh rate to minimize flicker, LCD or Flat Panel
technology is inherently flicker-free.
The monitor adopts Flicker-Free technology, which clears the eye visible flicker , brings
comfort viewing experience and preventing users suffer from eye strain and fatigue.
Note: If your system has previously been used with a CRT monitor and is currently configured
to a display mode outside the range of this monitor, you may need to reattach the CRT monitor
temporarily until you have re-configured the system; preferably to 1920x1080 at 60 Hz, which
is the Native Resolution Display mode.
The display modes shown below have been optimized at the factory.
Table 2-3. Factory set display modes
Timing Refresh rate(Hz)
640x480 60 Hz, 72 Hz
720x400 70 Hz
800x600 60 Hz, 72 Hz
1024x768 60 Hz, 75Hz
1280x1024 60 Hz, 75Hz, 100 Hz
1440x900 60 Hz
1600x900 60 Hz, 75Hz, 100 Hz
1680x1050 60 Hz, 100 Hz
1920x1080 60 Hz, 75Hz, 100 Hz
To Next Page
Loading...
