Appendix
8-26
L
_^ONMObk
8.5 Glossary
Technical term Meaning
Baud rate Transmission speed of data in bit/s
Broadcast Message to all controllers
Code For input and display (access) of parameter values.
Code number Addressing of variables according to the format „code-subcode“ (Cxxxx-xx). All variables can be accessed via the code names.
Fieldbus For data exchange between superimposed controls and positioning controls.
Host PC or PLC
Icon Sign or symbol with an unambiguous message.
Interface converter Additional module to adapt data transmissions via RS232 interface cables to RS485 (and vice versa)
LEMOC PC program (for IBM compatible PCs) for drive
programming
Multicast Message to certain controller groups
Nibble One byte consists of two nibbles:
• LOW nibble (bit 0 to 3)
• HIGH nibble (bit 4 to 7)
Protocol LECOM-A/B protocol
Pulse inhibit The output of the power stage is inhibited because the controller is inhibited, the fault message TRIP is displayed or an overvoltage or
undervoltage is applied.
Remaining hazards Hazards which cannot be eliminated by design
Subcode Defines the table position of a code
Table position Some variables may consist of more than one value. If this is the case, the values are entered subsequently. They are accessed by
means of the same code name via the subcode.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
