Appendix
8-4
BA2131EN
8.4 Table of keywords
A
Accessories, 8-1
Address
Bus, 6-3
Station, 6-3
Addressing of Lenze codes, 6-1
AIF-IN, Function block, 6-12
AIF-OUT, Function block, 6-13
Appendix, 8-1
Application as directed, 1-2
Application conditions, 3-1
Assignment of the process data, 6-9
B
Basic insulation, 4-4
Baudrate,3-1,6-4
See also
Baud rate
Bus address, 6-3
Buscable,4-6,8-1
Bus connection cable, 4-6
Bus-connector, 8-1
C
Check PROFIBUS, , 7-4
Codes, Possibilities, 6-1
Commissioning, 5-1
Initial switch-on, 5-2
Communication medium, 3-1, 3-2
Communication times, 3-3
Configuration, PROFIBUS-DP, 6-4
Connection
Connections of the fieldbus module, 4-1
Plug-in terminal (2-pole), 4-2
Control word, 6-17
Controller
Application as directed, 1-2
Labelling, 1-2
Controller status, 6-13
D
Definitions, 1-1
Device control, DRIVECOM, 6-14
Diagnostics, 5-4
Dimensions, 3-2
Disposal, 1-2
DP parameter-setting channel, 6-5
DRIVECOM
Control word, 6-17
Device control, 6-14
Status word, 6-20
DRIVECOM parameters, 6-2
E
Electrical data.
See
Ratings
Electrical isolation, 4-4
Enable controller, 5-3
F
Fault elimination, 7-1
Fault reset, 7-6
Fieldbus module
Connections, 4-1
Order designation, 3-1
Overview, 4-1
G
Glossary, 8-2
I
Index, 6-1
Initial switch-on, 5-2
See also
Installation
Installation
Electrical, 4-3
Mechanical, 4-3
Wiring to a host, 4-4
To Next Page
Loading...
