Configuration
7-2 UOMu_^MVMO
7.2 Code table
How to read the code table:
Column Abbreviation Meaning
Code C013 Code C013
D The parameter of the code can be different in PAR1 and
PAR2.
D The parameter value is accepted immediately (ONLINE).
C009* D The parameter value of the code is always the same in
PAR1 and PAR2, but is always displayed in PAR1.
C001¿ D The parameter value of the code will be accepted after
pressing SH+PRG.
[C002] D The parameter value of the code will be accepted after
pressing SH+PRG but only if the controller is inhibited.
Name
820X
Name of the code.
Unit-specific setting possibilites (here for 820X).
Without unit designation the code is valid for all unit types.
Lenze Factory setting of the c ode
* The column ”Important” contains further information
Selection 1{1%}99Minimum value {smallest step/unit} maximum value
Info - Meaning of the code
IMPORTANT - Additional, important explanations of the code
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
