Lenze g500-S Series - Commissioning; Important Notes

Commissioning
Important notes
Temperature ranges
The following temperature ranges are available matched to your ambient condions:
•
Default
•
Deep-freeze
•
Wide range
Check the ambient temperature and lubricant shown on the nameplate.
4Nameplates ^ 12
Pay aenon to the notes on the temperature ranges!
Temperature ranges
Standard
Ambient temperature 0 °C … +40 °C
Lubricant Mineral oil
•
CLP 460
Synthec oil
•
CLP HC 220
Food-compable oil
•
CLP HC 220 USDA H1
Note At an ambient temperature generally over +30 °C:
•
The applicaon case must be checked by Lenze.
Low-temperature
Ambient temperature -30 °C … +10 °C
Lubricant Food-compable oil
•
CLP HC 46 USDA H1
Note When starng a cold motor at below -20 °C, increased starng torques are to be expected due to the higher
viscosity of the roller bearing grease.
•
During project planning, allow a motor starng torque reserve of about 20%.
Commissioning at over +10 °C:
•
Operate the drive at max. 50% of the rated torque to avoid a reducon in service life.
Wide range
Ambient temperature -30 °C … +40 °C
Lubricant Synthec oil
•
CLP HC 220
Note When starng a cold motor at below -20 °C, increased starng torques are to be expected due to the higher
viscosity of the roller bearing grease.
•
During project planning, allow a motor starng torque reserve of about 30%.
At an ambient temperature generally over +30 °C:
•
The applicaon case must be checked by Lenze.
At a constant temperature between -30 °C and -25 °C, the service life is up to 20% lower than with the low-
temperature range.
Commissioning
Important notes
47