Lenze g500-S Series - Page 55

Template: Dipscks for G50BS166
[mm]
100
50
100
M1, M6
M3
M4
M2
M5
How to check the lubricant level:
1.
Remove the control screw at the marked posion.4Venlaon ^ 23
2.
Insert the dipsck through the threaded hole. Observe the posion of the dipsck in the
template!
3.
Carefully pull out the dipsck and determine the lubricant level. The lubricant level must
be within the marked range of the dipsck.
4.
If the lubricant level is too low, top up lubricant unl the lubricant level is in the marked
area of the dipsck. If the loss is greater, determine the cause.
5.
Insert the control screw and ghten it to the specied torque.
Maintenance
Maintenance work
55