Lenze PROFIBUS E82ZAFPC001 - Page 51

Electrical installation
Wiring to a host
6
EDK82ZAFPC−001 DE/EN/FR 7.0
51

H2 VerdrahtLeitrechner−PBS_leitungsspezifikation
Basic design of a PROFIBUS network with RS485 cabling without repeater
starttec
8200 vector
8200 motec
+
E82ZAFPC0xx
starttec
8200 vector
8200 motec
+
E82ZAFPC0xx
starttec
8200 vector
8200 motec
+
E82ZAFPC0xx
333
1
222
0m
1200 m
E82ZAFP005
No. Element Note
1 Host E.g. PC or PLC with PROFIBUS master interface module
2 Bus cable Connects the PROFIBUS master interface module to the function
modules.
l The baud rate depends on the length of the bus cable (53).
3 PROFIBUS slave Applicable standard device (42)with function module
l Activate bus terminating resistors at the first and last physical
node (64).
 Note!
When using a repeater, max. 125 nodes can communicate via the PROFIBUS.