LD5208 USER MANUAL, REV. 0: NOVEMBER 2005
17
10.3 Weighing
To weigh an item:
1. If the item comes in a container, the scale needs to be tared first (see previous paragraph)
2. Place the item on the scale
3. Wait for the display to stabilize (the status annunciator turns ON)
4. The weight of the item is to read on the indicator’s display
10.3.1 Accumulating the weight measurements
The indicators LD5208 provide the facility of adding each measured weight to an accumulated
total. This could be useful for the operator to check how much has been weighed on the scale over
a certain period of time.
Set up requirement: Parameter Setup 1, 1.1 =1
1. Place the item on the scale
2. Press the key (. The measured weight is added to total
3. Press key <. The display shows the current total
4. Press key < again. The display shows the number of all accumulated weights (no. of
measurements)
5. Press key < again to return to the normal weight display OR
PRESS KEY ( TO PRINT AND RESET THE total .
.
..
. Pressing the Print key causes data output to a printer or PC in the form :
Current serial number – total weight
.
..
. Pressing the Print key clears the totalizing memory
To Next Page
Loading...