Descaling
When the milk reservoir is in place, the appliance will prompt the user to
descale by flashing six indicators alternately. To initiate descaling, fill the
water tank with 600ml of clean water and dedicated descaling solution.
Press the Espresso and Latte buttons simultaneously, and the appliance
will enter descaling mode automatically. During this process, the six
indicators will flash alternately at a slow pace. After approximately half
an hour of operation, the indicators will flash alternately quickly, signaling
the user to empty the water tank. Refill the tank with 600ml of clean water,
then press the Espresso and Latte buttons simultaneously to resume
descaling. Once again, the indicators will flash alternately slowly until the
process is complete, at which point the appliance will return to standby
mode.
Preparation
a. Before preparing your latte, customize the quantity of frothed milk to
your liking by adjusting the Froth Control Knob.
b. Turn it to the right “ ” for more froth or to the left “ ” for less froth.
c. Press the Latte Button once to brew a small cup of latte.
d. Press the Latte Button twice to brew a large cup of latte.
15
Normal Froth Less Froth
More Froth
To Next Page
Loading...