4. Consult the instructions in the “Filter Insertion” section before placing
or removing the pressurized filter from the unit.
5. To clean the inside of the appliance, adhere to the steps listed in the
“Preparing Cappuccino” section, using only water in both reservoirs and
ensuring no coffee is in the filter. Do not immerse the appliance in water
or attempt to reach any of its internal parts.
Note: For consistent performance, clean your unit after every use.
To prime the unit, run the steam cycle for 90 seconds by following these
steps:
1. Fill the water tank to a level between the “Min” and “Max” indicators.
2. Fill the milk tank with water up to the level between the “Min” and
“Max” indicators.
3. Choose a filter and install it in the pressurized funnel assembly.
Ensure it is securely locked in place and position a cup under the frothed
milk dispensing tube to capture the output.
4. Connect the appliance to the appropriate power outlet.
5. Turn the unit on by switching it to the “I” position.
6. The six control panel lights will begin to blink. Once they stabilize, press
the cappuccino button twice.
7. After this process, the lights on the control panel will remain illuminated,
indicating that the unit has been primed and is ready for use.
7
Prepare the Unit
Select the Correct Cup
Before preparing your beverage, ensure you choose the appropriate cup
size as outlined in the table below:
To Next Page
Loading...