Maintenance
Note:
1. You can activate any function by pressing its corresponding button when
the appliance prompts you to descale. The appliance will continue to
remind you to descale even after completing the selected function.
2. The descaling process can be halted at any time by pressing any button.
However, the appliance will continue to remind you to descale until the
entire descaling process is completed and it returns to normal standby
mode.
A. Cleaning the Froth Tube
Even though you can store the milk reservoir with leftover milk in the
refrigerator, it's essential to clean the reservoir and frothing tube regularly
to prevent clogging and residue buildup. To clean the milk reservoir,
follow these steps:
1. Remove the milk reservoir from the unit.
2. Take off the reservoir lid.
3. Detach the steam tube connector by rotating it; clean it with tap water
and reattach it to the milk reservoir lid by rotating.
4. While cleaning the milk reservoir, open the silicone sheet (do not pull
it out) and wash it with tap water. After cleaning, replace the silicone sheet.
5. Empty any remaining milk and thoroughly rinse and wash the milk
reservoir and lid with warm soapy water. Avoid abrasive cleaners and
scouring pads, as they can scratch the finish. The milk reservoir is
dishwasher safe (top rack), but do not place the lid in the dishwasher.
6. Position a large empty cup beneath the frothing tube.
7. Turn the Froth Control Knob clockwise to the "Clean" position (“ ”),
then press and hold the Latte/Clean button for 3 seconds before releasing
it to activate the cleaning function. The unit will begin releasing steam
16
To Next Page