through the frothing tube; allow it to run until no milk is visible in the cup.
Press the Latte/Clean button once to stop the process when finished.
8. Dispose of any water remaining in the milk reservoir and return it to
the unit.
Note: To disassemble the milk reservoir, slightly raise it and then pull it out.
B. Cleaning the Filter
1. Turn the power button on the side of the unit to the off position “O” and
disconnect the power cord from the electrical outlet.
Caution: Some of the metal parts may still be hot. Refrain from touching
them until they have cooled down.
2. Remove the porta-filter and dispose of the coffee grounds or used pod.
Clean both the porta-filter and filter with warm soapy water, ensuring
thorough rinsing.
3. Do not wash the filter and filters in the dishwasher.
4. Use a damp cloth or paper towel to wipe the lower part of the brew head
in the unit, removing any residual coffee grounds.
5. Reinsert the porta-filter (without any filter) back into the brew head in
the unit.
6. Position an empty large cup beneath the porta-filter.
7. Press the espresso button once and allow the unit to brew with water
only until it stops automatically.
17
Rinse with Water
To Next Page
Loading...