is unplugged. Fill the unit with 400ml of white vinegar and 600ml of water
in the water tank. Assemble the milk tank into the unit and turn the frothing
control knob clockwise to the clean position.
2. Turn the power switch to the "On" position. The Cappuccino and Latte
indicators will blink alternately. Press the Espresso and Latte buttons
simultaneously; the unit will then enter descaling mode. The six indicators
will blink in a circular motion clockwise, and the frothed milk dispensing
tube will emit hot water and steam. After 10 minutes, the unit will switch
to standby mode, and the six indicators will light up.
3. Remove and discard the residual descaling solution, and clean the
water tank. Refill it with an appropriate amount of pure water. Brew two
cups of Espresso continuously, then two cups of Latte; once the six
indicators illuminate, the cleaning is complete, and the unit will return to
standby mode. After the unit completes another 500 cycles, it will activate
the descaling reminder again.
Note: Even under descaling reminder status, you can still operate the unit
normally. After operation, it will return to the descaling reminder status.
21
Troubleshooting
Problem
Cause Solution
Coffee does not come out.
Coffee leaks around the
edge of the porta-filter.
1.
No water in the reservoir.
2.
Coffee grind is too fine.
3.
Too much coffee in the
filter.
4.
Appliance was not turned
on or plugged in.
5.
Coffee has been tamped/
compressed too much.
1.
Porta-filter not rotated to
full lock position.
2.
Coffee grounds around the
filter basket rim.
1. Add water to the reservoir.
2. Use a medium grind for the
coffee.
3.
4. Ensure the unit is plugged in
and turn it on.
5. Refill the filter basket with
coffee, avoiding over-tamping.
3.
Too much coffee in the filter.
Fill the filter with less coffee.
1. Rotate the filter holder to the
full lock position.
2. Clean any coffee grounds
from the rim.
3. Use less coffee in the filter.
To Next Page
Loading...