9
6、CLICK “OK” and Close the Local Area Connection Properties window
Figure 3-1-14
3.2 Check the connection
After setting the TCP / IP protocol, you can use the Ping command to verify whether the computer can communicate with
Web-Smart Switch. To perform a ping command, open a command window, the IP address in the command prompt where
the Ping Web-Smart Switch
Windows XP，START-Control，type cmd in the search bar and press Enter Windows 7，Click Start, type cmd in the search
bar and press Enter where the DOS prompt, enter the following command.
If the command window return to something like the following:
Figure 3-2-1
To Next Page
Loading...
