23
Select a aggregation group number, then add port in the left form to the right form, that make port join into aggregation
group. Web-Smart Switch has max 8 groups, and one aggregation group can support max 8 member ports.
5.5 Port-based Mirroring
Port mirroring allows you to duplicate the packets passing specified ports to the destination mirroring port. As destination
mirroring ports usually have data monitoring devices connected to them, you can analyze the packets duplicated to the
destination mirroring port on these devices so as to monitor and troubleshoot the network.
Figure 5-5-1
Choose the menu Configuration→ Port-based Mirroring to load the following page.
Select the Source Port from where you want to copy frames and the Target Port, which receives the copies from the
source port.
1. Change the Port-base Mirroring Status menu to On.
2. Click Apply to let the changes take effect.
3. Select the Source Direction, RX, TX, Both.
5.6 Port Isolation
To implement isolation, you can add different ports to different VLANs. However, this will waste the limited VLAN
resource. With port isolation, the ports can be isolated within the same VLAN. Thus, you need only to add the ports to the
isolation group to implement isolation. This provides you with more secure and flexible networking schemes.
Choose the menu Configuration→ Port Isolation to load the following page.
Figure 5-6-1
To Next Page
Loading...
