13
You are kindly suggested to retype the new password in "Confirm new password" box instead of copying in order to avoid
typing mistakes.
Caution:
Only letters, numbers and punctuations can be input into username and password. The other characters are considered
illegal. The initial password is admin.
Notes:
After modifying the password with immediate effect, the parameters will not be lost though is powered off.
4.5 Port Setting
Figure 4-5-1
On this page, you can configure the basic parameter for the ports. When the port is disabled, the packers on the port will
be discard. Shut down the port which is vacant for a long time can reduce the power consumption effectively. And you can
enable the port when it is in need. The parameters will affect the working mode of the ports, please set the parameters
appropriate. Status: Allows you to Enable/Disable the port. When Enable is set, the port can forward the packets
normally.
Speed and Duplex: Select the speed and Duplex mode for the port. The device connected to the switch should be in the
same Speed and Duplex mode with the switch. When “Auto” is set, the Speed and Duplex mode will be determined by
auto-negotiation. But the SFP port, this Switch does not support auto-negotiation.
Flow Control: Allows you to Enable /Disable the Flow Control feature. When Flow Control is enabled, the switch can
synchronize the speed with its peer to avoid the congestion.
To Next Page
Loading...
