Levoit LV-H132 User Manual

11
KEEPING THINGS CLEAN
Cleaning the Air Purifier
Check Filter Indicator
Resetting the Check Filter Indicator
• Unplug before cleaning.
• Wipe the outside of the air purifier with a soft, dry cloth.
If necessary, wipe the housing with a damp cloth, then
immediately dry.
• Do not clean with abrasive chemicals or flammable
cleaning agents.
The Check Filter Indicator will light up as a reminder
to check the filters. Depending on how much you use the
air purifier, the indicator should turn on within 6–8 months.
You may not need to change your filters yet, but you should
check them when the indicator light turns on.
Reset the Check Filter Indicator when:
• lights up.
1. Replace the filters (see page 12).
2. While the air purifier is plugged in and turned on,
press and hold for 3 seconds until the air
purifier beeps.
3. The light will turn o once it is successfully reset.
• The filters were changed before lit up.
1. While the air purifier is plugged in and turned on,
press and hold for 3 seconds until the air
purifier beeps. This will turn the indicator light on.
2. Press and hold again for 3 seconds until the air
purifier beeps.
3. The light will turn o once it is successfully reset.
Cleaning the Filters
A. The Pre-Filter should be cleaned once a month to
increase eciency and extend the life of your filters.
Clean the Pre-Filter using a brush to remove hair, dust,
and large particles. Optionally, rinse the Pre-Filter in
clean water.
B. Do not clean the True HEPA Combination Filter. Fine
dust or bacteria may be released back into the air if
cleaning is attempted, and the filter will be permanently
damaged. Only clean the Pre-Filter.
Note: Always make sure the Pre-Filter is completely dry before
using, because dampness or moisture will damage the True HEPA
Filter.
1
1
1
A
B
C

Levoit LV-H132 Specifications

General

Power Consumption	28W
Fan Speeds	3
Voltage	120V
Color	White
Filter Type	HEPA
Coverage Area	129 sq ft
Noise Level	50 dB
Room Size	86 sq ft